Monday, April 14, 2014

Cheap Drill Batteries! Making a Corded Cordless Drill

This was a quick afternoon project that I worked on a few weeks ago. The beginnings were pretty simple. I was digging through the basement and found an old 12v cordless drill whose batteries had died. Being me, I decided that it would be cool and pretty easy to connect a cord to it and plug it into a lab power supply or other 12V source.


As this project is pretty dependent on the type of drill you have, I will try to include what pictures I took. Also, it is worth noting that as I type this Walmart has plenty of decent corded and even cordless drills for less than $40.

Step 1)
Take apart the battery. Determine the positive and negative leads. On mine white = negative,  black = positive (similar to wiring a house).


Step 2)
Aquire a cord. The wire I scavenged is suspected to have come off of an old vacuum. I would recommend scavenging for this project to keep costs down. I also found some banana plugs to make it easier to connect to a power supply. I considered using some old test lead alligators.

The kind of Banana Jack I used

Step 3)
Remove the batteries and wire together. I actually left some of the batteries in the casing to add some counterbalance. I then soldered on the wire, punched a hole in the case to let the wire out, and hot glued everything together.

Step 4)
Test. My next step was to hook it up to a car battery and test it. It worked! for a few seconds. Then the burnt smell.

The drill did not like being run on a car battery. There is a large diode inside the drill that I burnt out. Luckily, I found a replacement in a box of old hairdryers that we happened to have on hand.

With the replacement diode in, I took it over to a lab and tried it out. It worked fine. There was still a slight burning smell, but I suspect that may just be dust in the motor from years of non use. Overall it seemed to work ok. The video below will give you a peak at the power supply readout during testing.



Some might call this a wasted Saturday afternoon, and they are probably right. However, if you enjoy tinkering with things, making a corded cordless drill might be right up your alley.

-Matthew

3 comments:

  1. I made almost the same with my 12V cordless drill, but I soldered the wire to connectors of the battery inside my drill, so I can use it with battery or with 12V power supply or with battery and power supply in the same time.

    ReplyDelete
  2. This is a good idea, I'm a little bit tired in charging and changing the battery of my
    makita 18v cordless drill. I'll try to do this!

    ReplyDelete